Ac works hot pipe is hot cold pipe is cold.
2011 ford fusion blend door actuator problems.
Your order may be eligible for ship to home and shipping is free on all online orders of 35 00.
The blower motor and blend door actuators are both mechanical devices and as with all such components prone to failure.
Blend door seems to be stuck in full hot poition.
The fcim is the my last guess.
Temp switch cranked full cold or full hot position i get full hot blowing out vents.
Having hvac problems on my 2010 fusion.
Check here for special coupons and promotions.
I ve been doing some research and it seems like a lot of people have this issue with this particular car.
Ford climate control relies on a series of ducts and a blower motor as well as a blend door assembly and blend door actuator to properly route the warm or cold air from the ac or heater into the cabin.
Best advice for diagnosing and fixing a ford heater blend door actuator problem.
Equip cars trucks suvs with 2011 ford fusion a c heater blend door actuator from autozone.
I have replaced the blend door and sensor in dash.
Order blend door actuator for your 2011 ford fusion and pick it up in store make your purchase find a store near you and get directions.
An actuator can go bad in of two ways.
A problem with the blend door actuator motor in which case you must replace the actuator or a problem with a binding or stuck blend door.
2012 fusion blend door.
We have the best products at the right price.
Had no ac this morning all worked 100 last night no problems.
120 later i still have the same issue.
First the electric motor can burn out rendering the unit non responsive so nothing changes when the temperature or.
However i found that it i put temp switch in the dead middle position.
A blend door actuator is made up of an electric motor that turns a plastic gear set in one direction or another which is connected to an air control door pivot at the final drive of the unit.
I have a 2011 ford fusion with a little over 130 000 miles.