General nissan altima discussion 1993 2001 hey i have a 99 nissian altima 2 4l and my brakes needed to be changed so i changed them well my passenger side locked up so i put the old brakes back on that side well it got to where i needed to change them and they are still sticking so i cut the fluid off to that side removed the brakes and.
2001 nissan altima door lock problems.
Replaced battery o2 sensors spark plugs plug wires distributor cap flushed cooling system front brakes gas cap pcv valve soon oil change 3000 miles replaced all evap hoses.
I put new tires on.
2001 nissan altima gxe i had the car donated by a abbott.
If a door is opened and closed at any time during one ignition cycle off on even after initial auto door lock has taken place the vehicle will relock all doors when the vehicle speed reaches 15 mph 24 km h or more again.
As for all four door lock actuators being bad i would never had believed it until i saw an 05 maxima with the same problem.
Have to replace tie rod boots.
It is located behind the driver s left side kick panel.
All things altima coupe.
Doors lock and unlock while driving and after engine is off and key is out of ignition i have had to remove fuse because it is so irritating while driving.
All doors are locked when the vehicle speed reaches 24 km h 15 mph or more.
To unlock the doors the switch reverses the polarity of the voltage applied to the solenoid.
A mechanic can often tell by the sound whether the problem lies with the fuse the power door lock switch or the power door lock actuator.
6 posts page 1 of 1.
Gle gxe se xe.
I have a 2001 nissan altima gxe i think.
Parts fit for the following vehicle options.
193 000 miles put 2000 plus since gifted.
Just pull the panel away and the relay is held to the sheet metal with a 10mm bolt.
2002 nissan altima 2003 nissan altima.
Doors lock i have a 2001 nissan altima gxe i think.
Parts like front door lock handle are shipped directly from authorized nissan dealers and backed by the manufacturer s warranty.
An inoperative power door lock can be caused by the switch solenoid wiring problem or mechanical problem within the linkage of the affected door.
After determining the problem with the system the malfunctioning piece will be replaced.
To lock the doors the switch provides voltage to the two terminals of the solenoid.